Dishwasher Repair – Replacing the Track Roller Kit (GE Part # WD12X332)

explain you how to change

Hi it’s Ervin from

screwdriver we are simply

we are going to explain you how to change the track roller kit on your dishwasher and it’s a really easy job, all you are going to need is a small flat blade screw driver and a Philips screwdriver, let me explain you how we do Best appliance repair. ll reinstall the Now the first step in this repair will be to open the dishwasher door, and we are going to pull the upper rack out and completely empty it, and we’ll need to remove the rack from the rails, so once we've emptied it, we will take a flat blade screwdriver and we’ll pop those rack stops off, just depress the locking tab, and slide the rack stop off the end and the same on both sides, and just depress them enough that they will clear that catch, slide the upper rack completely out, and then the roller that we are going to remove, we’ll also need to take that track completely off, so we’ll need to remove the rack stop on the backside of it, and it's identical to the one on the front, so just depress the stop and push it off, set that aside and then completely slide the rail over the rollers, then with the Philips screwdriver we are simply going to unscrew that center axle on that roller, there are two different styles supplied with this kit, so match it up with the style that is on your dishwasher, some have a fixed rear washer on them, and the other ones have a separate washer, so whichever one your dishwasher is using that’s one you will replace it with, simply line up the new roller, thread it into place, make sure it is tightened firmly, verify that the roller still turns and we’ll take our rail, slide that carefully through both rollers, we’ll reinstall the rack stop on the end, and the catch goes on the outside, it is snapped in place so that it locks, pull both rails forward, we’ll reinstall the upper rack, and then we will put the rack stops in place again making sure that they latch firmly, and our repair is complete. I told you it was an easy job, thanks for reading and good luck with your repair.